Reflective Spray - Textile

Senfineco Reflective Spray is a transparent spray with light-reflective Properties that sticks to most surfaces, and resists wind and rain. The spray is UV-resistant and is durable on most materials such as textiles, wood, concrete, metal, stone etc. It either comes easy to wash off for temporary use or as an long lasting permanent spray. In any case it is great for use on textiles, bikes, scooters, on building sites, roadside works and any hardware that might be used in low light.

Senfineco launched the Reflective Spray Textile to increase the visibility and safety on the road. This safety spray contains powder-fine reflective particles that shine bright white when hit by a car’s headlights. The paint is invisible grey in daylight, but in the dark it reflects light in the same direction as the light source to illuminate the objects it has been sprayed on. Dispensed in a spray can, it’s a water-based the paint can be washed off, and with the spray able to hold its coat on, practically, any surface, allowing it to be applied to bags, shirts, helmets, dog leashes and obviously, bikes.

Properties

  • releflects the light towards the source of illumination
  • non-poisonous
  • transparent / slight gray shimmer
  • easy to wash off

Application

Make sure the object to be sprayed is dry, and that dirt, grease and other loose particles are removed before application. Some surfaces and certain plastics may need to be treated with a primer before use in order to achieve optimum and durable results over time. You can easily create reflective signs and symbols by cutting out, and spraying on with stencils.

  1. Always spray outside or in well-ventilated areas. Shake the can vigorously +1 minute (at least 20 sec after you hear the bulb inside). Repeat during application.
  2. After shaking, spray immediately from a distance of approximately 25 cm, with even swiping movements. Hold the can upright while spraying. Do not over-apply. Dries in a couple of minutes at normal room temperature.
  3. Clean the nozzle after use, by spraying upside down for 1-2 sec